94
Endura
®
Delta
en
User
When the Fireplace function is active, more air is supplied than extracted so that
the fire burns better and residual smoke is kept to a minimum.
The frost protection is activated when the temperature of the incoming air is too
cold. The Frost Protection function keeps the heat exchanger from freezing.
Indicates that the filters must be cleaned or replaced.
These settings can be changed via “Settings > My unit filter”.
The danger sign indicates that a critical error has occurred in your ventilation
system. You are advised to contact your installer in this case.
− Messages:
10.2.2 • Timer
You can activate a timer using this menu, which will allow the system to deviate from the pre-
programmed ventilation level for a certain amount of time.
You can choose between “Timer mode”, “Manual Breeze” and “Holiday mode”.
Tip: If you drag the slider in the Home menu, you can immediately set a timer.
10.2.2.1 • Timer mode
In the “Timer mode”, you can choose a certain ventilation level for a specific period of time.
• You can do this by selecting the ventilation level with the slider bar and
entering the desired time using the arrows and then tapping “Start”.
• When the timer is complete, the system returns to its original program
mode.
Note:
As long as the timer is active, the demand side of the Endura Delta
remains deactivated. Therefore, the ventilation system will not change
the ventilation flow rate while the timer is running based on the
measured air quality (relative humidity, VOC or CO
2
).
FIRE PLACE
FROST PROTECTION
FIRE PLACE
FROST PROTECTION
Summary of Contents for Endura Delta 330
