40
Endura
®
Delta
en
Installer
8.1.1.3 • Configuring the Wi-Fi
The Endura Delta must be connected to the Wi-Fi network in order to operate/configure the
Endura Delta using the Renson Ventilation app.
If there is no Wi-Fi connection available on-site, the installer must use his/her own router to start
up the Endura Delta. This router can be removed after configuring the ventilation unit. The end
customer must add the Endura Delta to his/her own home network himself/herself upon putting it
into operation.
Connect the router and go to “Settings” on your smartphone/tablet. In the Wi-Fi connection menu
here, find the LAN connection for your router and activate this. Your smartphone/tablet is now
successfully connected to the router.
8.1.1.4 • Opening the app
After your smartphone/tablet is connected to the network (LAN or Wi-Fi), you can open the
Renson Endura Delta Ventilation app. The following screen opens: Adding/changing devices.
Your smartphone looks for RENSON
®
units that are in the network.
If the Endura Delta is turned on and connected to the network correctly,
then this appears in this menu.
Tick the Endura Delta and then tap “Continue” to add the unit to the
network.
If the unit is not found, tap “Search” again. Ensure that your smartphone
is connected to the correct network.
If you are outside of the network’s range, the screen on the left appears.
Go somewhere where you are within the network’s range and retry the
steps above.
Summary of Contents for Endura Delta 330
