53
Endura
®
Delta
en
Installer
8.2.1 • Starting the TouchDisplay
• If you want to start up an external Master TouchDisplay (Main Controller), you must connect this
to the main printed circuit board using a cable (see Section 7.1.1). The Master TouchDisplay is
powered by the main printed circuit board.
• If you want to start up the air quality sensor, this must be connected to the mains voltage.
Before a TouchDisplay control can be put into use, the following steps must be taken when starting
up the TouchDisplay (only the first time):
− Set the TouchDisplay as the Main Controller or Sensor Controller
− TouchDisplay country selection
When connecting to the mains voltage, the screen for which the TouchDisplay will be used as
MAIN Controller or as SENSOR Controller appears.
You must use the
▼
and
▲
buttons to make your selection. Confirm your
choice by tapping
■
.
The choice is determined as follows:
− If 1 TouchDisplay is used to control the Endura Delta, select MAIN Controller.
In this case, the built-in TouchDisplay in the front panel of the unit is used as the MAIN Controller.
Slave
Slave
Slave
Master
RF
Ethernet
Wifi
Slave
Slave
Slave
Master
RF
Ethernet
Wifi
Slave
Slave
Slave
Master
RF
Ethernet
Wifi
Summary of Contents for Endura Delta 330
