55
Endura
®
Delta
en
Installer
8.2.1.1
•
Making the TouchDisplay the Main Controller
When connecting to the mains voltage, the screen for which the TouchDisplay will be used as
MAIN Controller appears.
Select “Main Controller” using the
▼
and
▲
buttons, and confirm your
selection by tapping
■
.
The “Select Region” screen appears. Use the
▼
and
▲
buttons to select
your country, and confirm by tapping
■
. The factory settings for your
choice of country are loaded.
After confirming your country, the Main Controller menu opens.
You can now begin correctly programming the Endura Delta. Use the
Installer menu “Settings > Installer settings > Flow rate settings” for this.
See Section 8.2.3.1.
Note:
A Main Controller must always be connected to the Endura Delta using a cable. Therefore,
the Main Controller TouchDisplay cannot communicate wirelessly with the unit. If you install
external sensors (Sensor Controller), then these can communicate wirelessly with the Main
Controller.
Summary of Contents for Endura Delta 330
