5
0027364-00_BEDBWRTAQP 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
03 DESIGN
04 BEFORE USE
05 DURING USE
The bath with back therapy/Aquapuncture is fi tted with a jet pump installed under the bathtub. This
pump draws in the bath water and directs it into the bath via the conduit system and nozzles.
The jet pump is controlled via a key on the side of the bathtub.
- Rinse out the bath with cold water.
- Close the bathtub drain.
- Fill the bath with hot water.
Important:
Since water must fi ll part of the piping system before the bathtub can be fi lled, it takes
some time for the water to visibly collect in the tub.
To enable the use of back therapy/Aquapuncture, fi ll the bath up to around the overfl ow with
the user(s) inside.
Press the key on the side of the bathtub once to switch on the
pump. The LED illuminates when the pump is switched on.
Press the key again to switch the pump off.
If the
LED fl ashes when you press the key, there is not enough
water in the bath. In this case, add more water.
Safety shutdown
The pump switches off automatically 20 minutes after activation.
The pump remains in standby mode and can be reactivated at any time.
Operation
