17
0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Manual disinfection
(Vision 700 or Vision 1000 control panel without an automatic disinfection system and Vision 500)
Make sure the bath is filled up to at least
5 cm above
the jet or micro jet nozzles before disinfection!
- Add the disinfectant to the water after bathing:
Use approx. 80 - 500 ml, depending on the bathtub size (concentration 100 ml to 100 l of water).
- Let the disinfectant solution react for approx. 30 minutes.
- During this period, run all the available whirlpool systems (air and jet) 3 times for 1 to 2 minutes.
- Switch off the whirlpool, open the bathtub drain and let the disinfectant solution drain out.
Automatic blow-out starts once the bathtub has fully emptied (Vision 500 and Vision 1000).
The fan is automatically de-activated after the end of the blow out time.
After approx. 5 minutes, dry the air nozzles and bathtub with a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Automatic disinfection
(a special accessory, only for Vision 700 and Vision 1000)
Make sure the bath is filled up to at least
5 cm above
the top nozzles before disinfection!
Start the disinfection process after bathing and with a full bathtub:
Using the Vision 700 control panel
- Press and hold the
key until the pump switches on (approx. 5 seconds)
and the key slowly flashes.
If the
key flashes quickly, the disinfectant tank must be topped up (please refer to “Servicing”
on page 20).
- Automatic disinfection is started.
- The running time for the automatic disinfection is approx. 30 minutes.
- After automatic disinfection, the
key illumination goes out.
- Press the
key again to stop automatic disinfection at any time.
- Once the disinfection process is complete, open the bathtub drain and let the
disinfection liquid drain out.
- After approx. 5 minutes, dry the air nozzles and bathtub with a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Usage / Disinfection
Summary of Contents for Vision 1000
Page 27: ......
