19
0022771-01_BEDWHPV.1 12/2021 •
repa
BAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Using the Vision 700 control panel
- Press the
key when the bathtub is empty.
- Fresh water rinsing is started, the
key is illuminated until the end of the rinsing programme
- Press the
key again to interrupt fresh water rinsing at any time.
- The fresh water rinsing ends when the rinsing time has elapsed.
- After approx. 5 minutes, dry the jet nozzles and bathtub with a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Using the Vision 1000 control panel
- Press the
key when the bathtub is empty.
Fresh water rinsing is started,the
key is illuminated.
- The display shows
5 P.
(with flashing dot).
- Press the
key again to interrupt fresh water rinsing at any time.
- The fresh water rinsing ends when the rinsing time has elapsed.
- The automatic blow-out is activated once the bathtub is drained.
This programme cannot be cancelled.
- The
key flashes and the remaining time until the end of the programme
is shown on the display in seconds.
- After approx. 5 minutes, dry the air and jet nozzles and bathtub with a soft,
non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
09 CARE INSTRUCTIONS
Do not use cleaning agents which contain solvents, are aggressive or abrasive! They damage
the bathtub surface. Only use soft, non-abrasive and lint-free cloths for cleaning!
The bathtub surface must be freed of abrasive dust etc. before cleaning, e.g. by rinsing it with
clear water. Chemical drain cleaners may not be used.
After bathing, clean the bathtub with a household cleaning agent. Clean the acrylic parts at regular
intervals with anti-static Repabad “Special cleaner” acrylic and plexiglass cleaner (art. no. 0010276).
To deal with minor scratches, use Repabad’s “Acrylic care set” (art. no. 0007135).
Disinfection / care instructions
Summary of Contents for Vision 1000
Page 27: ......
