KrosFlo® TFF System – Auxiliary Scale ACSS-60K
User Guide
25 repligen.com 420-14871-002 Rev. 00
4.
Select respective option and press
key to confirm, first, text
<LoAd>
is displayed for 1
second, next you see a weighing window.
5.
If the parts are to be weighed in a container, first put the container on a weighing pan and
tare it.
6.
Load the weighing pan with the declared amount of parts. When the indication is stable (
pictogram is displayed), press
key to confirm the mass.
7.
Single part mass is calculated automatically, the quantity of parts (pcs) is displayed.
Note:
Total weight value of all parts loaded onto the weighing pan cannot be greater than the max
capacity value.
Note:
Single part mass value must be equal or greater than 0.1 of the reading unit. Unless this
condition is met, the weighing device displays a message
<ErrLo>
.
Note:
In the course of parts quantity determination it is necessary to wait for a stable measurement
before confirming the declared quantity value.
14.
Working mode - +/- control
+/- control is working mode enabling to enter checkweighing threshold values (
Min
,
Max
).
14.1
Local settings
To go to local settings, enter
<3.3.HiLo>
submenu.
Table 14. +/- control – Local settings
Submenu
Setting
3.3.1.Acc
Working mode accessibility
3.3.2.Snn
Save mode
3.3.3.Int
Time interval
3.3.4.Lo
Lo threshold
14.2
Declaring checkweighing thresholds
1.
Enter
<HiLo>
working mode (+/- control), first, text
<SEt Lo>
is displayed for 1 s, next you see
a window for declaring low weighing threshold (Min).
2.
Enter a respective value and press
key to confirm, first, text
<SEt Hi>
is displayed for 1
second, next you see a window for declaring high weighing threshold (Max).
3.
Enter respective value and press
key for confirmation, working modes home screen is
displayed along with the declared threshold value, where:
Min
– Load mass lower than low
weighing thresholds,
Ok
– Load mass within weighing thresholds,
Max
– Load mass greater
than high weighing threshold.
Note:
If the entered low threshold value (Min) is greater than the high threshold value (Max),
<Err
Lo>
error is displayed.
