88
3. Servo ID -- Servo ID can be edited by click on ‘Edit’ button. Valid ID range is between 0 to 253. It’s recommended NOT to edit
the pre-set Servo ID to prevent having two Servo motors with the same ID in your rero system.
Editing Servo ID
4. Servo Name -- You can give a name to the selected servo motor to improve the readability of your program.
5. Servo Mode & Diagram -- Configures the selected Servo to Position mode or Wheel mode. The diagram shows the moving
path in when Servo is in Position mode or wheel image in Wheel mode.
Position mode
Wheel mode
Press ‘Save’
Edit Servo ID
Moving path
Restricted zone
Position mode
selected
Wheel
Wheel mode
selected
Summary of Contents for rero2.0
