Residentia RH94G, User Manual

Residentia

\

10

Operation in case of emergency 

In the event of an emergency you should:

–   Switch off all rangehood controls.

–   Switch the rangehood off at the power outlet and immediately unplug.

–   Call the Residentia Support Team on 1300 11 HELP (4357).

 Some minor faults can be fixed by referring to the instructions given in the 

Troubleshooting section below. There is also a self-help section online at 

http://www.residentiagroup.com.au.

 Important!

 If your appliance appears to be operating incorrectly, then 

you should disconnect it from your electrical supply and 

then contact the Residentia Group Support team on 1300 

11 HELP (4357).

Warning! 

 Do not attempt to repair the rangehood yourself.

 Please note that if an engineer is asked to attend whilst the product is under 

warranty and finds that the problem is not the result of an appliance fault, then 

you may be liable for the cost of the call out charge.

 The appliance must be accessible for the engineer to perform any necessary 

repair. If your appliance is installed in such a way that an engineer is concerned 

that damage will be caused to the appliance or your kitchen, then they will not 

complete a repair. This includes situations where the rangehood has been tiled 

in or sealed in with a sealant.

 Please refer to the conditions of that appear on the warranty card at the rear of 

this user manual. 

Fault:

Common Cause:

Common Solutions:

The lights work, however the motor 

does not work

The motor is blocked or jammed or 

the capacitor is damaged.

Call the Residentia Support team 

for further guidance.

The capacitor damaged

Call the Residentia Support team 

for further guidance.

Neither the lights or the motor works

Beside the above mentioned, check the following:

Light globes are damaged or blown

Replace the light globe(s)

The power cord is loose.

Ensure that the rangehood is 

correctly plugged in and the power 

outlet is switched on.

The rangehood is vibrating against the 

wall

The rangehood canopy is not fixed to 

the wall correctly. 

Ensure that the internal safety 

screws have been used and tight.

Insufficient suction

The distance between the rangehood 

and your cooktop is too great.

Have your installer re-adjust the in-

stallation position, ensuring that the 

minimum distances are observed as 

per the building code.

Technical data 

Electrical details 

Rated Voltage: 

220 – 240 V, 50/60Hz

Troubleshooting & Technical Data

\