Resol 180 010 90, Manual

en

9

Technical data
Inputs: 

On / Off, 

bursts / wave packets, phase cutting

Outputs: 1 semiconductor relay, 1 PWM, 1 0-10 V
PWM frequency: 625 Hz +-2,5 %
PWM voltage: 11 V
Power supply: 220 … 240 V~  (50 Hz)
Supply connection: type Y  attachment
Power consumption max.  1.7 VA 
Mode of operation: type 1.Y
Rated impulse voltage: 2.5 kV~
Functions: signal converter, converting a speed-controlled 230 V signal into a 
PWM or 0-10 V signal.
Housing: plastic
Mounting: wall mounting
Protection type: IP 20 / DIN EN 60529
Protection class: II
Ambient temperature:  0 … 40 °C
Degree of pollution: 2
Dimensions: Ø  139 mm

2 

Installation

2.1 

Mounting

WARNING!

Electric shock!
Upon opening the housing, live parts are exposed!

Î

Always disconnect the controller from power supply 
before opening the housing!

The unit must only be located in dry interior rooms.
The controller must additionally be supplied from a double pole switch with con-
tact gap of at least 3 mm.
Please pay attention to separate routing of sensor cables and mains cables.

1 

Overview

The PSW Premium Pump signal converter is used for connecting speed-controlled 
high-efficiency pumps with a PWM or 0-10 V control input to a controller without 
a corresponding output. Thus, when replacing the pump, speed control can be 
enabled without replacing the controller.
The PSW Premium pump signal converter converts the 230 V signal of the con-
troller to which a standard pump had previously been connected, into a signal that 
enables speed control of a HE pump.
The PSW Premium is equipped with a relay output for the power supply of the 
pump. Moreover, it has an overrun function to reduce the number of switching 
processes for high-efficiency pumps.
•  For solar and heating pumps
•  PWM or 0-10 V output signal
•  Inversion of the output signal possible
•  Integrated power supply of the pump
•  Overrun
•  Pump status indication

1 HE pump per signal converter connectable.
The following signal conversions are possible:

Output signal

Input signal

PWM

PWM 

inv.

0-10   V

0-10   V 

inv.

On / Off

x

x

x

x

Burst / wave  packet

x

x

x

x

Leading-edge phase control

x

x

x

x

Trailing-edge phase control

x

x

x

x

Not suitable for heat pumps and DHW exchange controllers

139

45

Drill hole positions

113 mm

139

45