© RESOL 11089 deltasol_c2.monen.ind
d
|
8
D e lt a S o l
®
C2
3. Control parameters and display channels
3.1 Overview of channels
Legend:
x
Corresponding channel is available.
x*
Corresponding channel is available when the corresponding
option is enabled
Only if the option heat quantity measurement is
activated
(OHQM), will the corresponding channel be available.
MEDT
Only if an antifreeze (MEDT)
other than water or Tyfo-
cor LS / G-LS (MEDT 0 or 3)
is used, will the channel
antifreeze concentration (MED%) be displayed.
Only if the option heat quantity measurement is
deactivated
(OHQM), will the corresponding channel be available.
Note:
Only if temperature sensors are connected, will S3 and S4
be displayed.
channel
description
page
COL
temperature collector 1
9
TST
temperature store 1
9
S3
temperature Sensor 3
9
TRF
temperature return sensor
9
S4
temperature Sensor 4
9
n %
speed relay 1
9
h P
operating hours relay 1
9
kWh
heat quantity kWh
10
MWh
heat quantity MWh
10
DT O
switch-on temperature difference
11
DT F
switch-off temperature differ-
ence 1
11
DT S
set temperature difference
11
RIS
rise
11
S MX
maximum temperature store 1
11
EM
emergency temperature collector 1
11
channel
description
page
OCX
option collector cooling collector
1
12
CMX
maximum temperature collector 1
12
OCN
option minimum limitationcollec-
tor 1
12
CMN
minimun temperature collector 1
12
OCF
option antifreeze collector 1
12
CFR
antifreeze temperature collector 1
12
OREC
option recooling
12
O TC
option tube collector
13
OHQM
option heat quantity measurement
10
FMAX
Maximum flowrate
10
MEDT
antifreeze type
10
MED%
antifreeze concentration
10
HND1
Manual operation relay 1
13
LANG
language
13
PROG
program number
VERS
version number
