en
21
Installation
Eliminating er
rors
Configuration
W
eb interface
Displa
ys
Carry out the connection of the device
to the controller / other mod-
ules in the order described below:
Î
Connect the data cable (VBus
®
,
) to a controller
. If necessary, extend the
cable using the terminal block included and a 2-wire cable (bell wire).
Î
Connect VBus
®
accessory
via the data cable, if necessary.
If a further VBus
®
cable is to be connected, proceed as follows:
Î
In order to open the housing, unscrew the screw and remove the upper part
of the housing.
Î
Connect the 2-wire cable (bell wire) to the 2 VBus
®
terminals (A) and (B) with
any polarity.
Î
Close the housing.
(A) (B) (C) (D)
Connection terminals of the interface adapter
Î
Connect the device to the mains by means of the mains adapter
.
Î
For a direct connection to a router, connect the device to a router
using the
network cable (included with the device,
).
www
3.3
LAN connection
The device can be connected to a router by using a network cable (CAT5e, RJ45
or similar).
Î
Connect the network cable included to the LAN connector of the router and
to the LAN connector of the device.
For the next step of commissioning, see chap. 5 on page 23.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.