RE220T_2GIG_Repeater_Translator.doc
Page 3 of 4
11/29/2010 4:43:00 PM
www.ResolutionProducts.com
Specifications
Backup batteries:
Three AAA Alkaline.
External supply:
12V DC, at least 50mA.
Current draw with supply: 4mA, normal operation.
Power Fail Conditions:
12V DC gone. Translator device ID
supervisories (including low battery reports)
are stopped during 12V DC loss.
Back-up Battery Life on 12V DC Fail: 72 hours (cumulative).
Device Low Battery:
When approximately 48 hours remain in back-up.
Housing dimensions:
4x6x1 inches
Specifications subject to change without notice.
Internal Picture
Power Terminals
Tamper Switch & spring
Unused:
Device Type Indicator LEDs
and Enrollment button
Battery bucket for 3 AAA alkalines
Indicator LEDs & buzzer
2 Antennas for:
Dual Diversity Receive and
Dual Diversity Transmit
Note: Antennas mounted
on outer terminals
RE220T_2GIG_Repeater_Translator.doc
Page 4 of 4
11/29/2010 4:43:00 PM
www.ResolutionProducts.com
Notices
“GE”, “Honeywell”, “2GIG” and “DSC” are trademarks owned by General Electric Company,
Honeywell International Inc., 2GIG Technologies, Inc., and Tyco Safety Products Canada LTD,
respectively.
Resolution Products, Inc. products will function with one of either GE, DSC, 2GIG or Honeywell
systems. However, no Resolution product is produced by, endorsed by, nor is officially
associated with GE, Honeywell, 2GIG or DSC. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.
Do not use Translator for life safety devices, such as smoke or CO sensors.
Warranty
Resolution Products, Inc. will replace products that are defective in their first year.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X-RE224
IC Notice
This product meets the applicable Industry Canada technical specifications/Le présent
materiel est conforme aux specifications techniques applicables d’Industrie Canada.
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 2 dBi. Antennas not included in this list or having a gain greater than
2 dBi are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.
- Resolution-supplied 8.5" monopole antenna
IC: 8310A-RE224
