Doc. No. 0175820 rev. F
Page 11 of 16
Prepare the faceplate - Trimmer Installation
Mark target hole.
Drill target hole.
Remove debris and
insert trimmer,
Make trimmer flush
even on the external
side of faceplate.
Use Loctite 416 and
glue around the trim-
mer (internal side).
Let it cure.
NOTE :
Do the same process
for additional trimmers. Let the
glue cure first then operate the
trimmer to ensure that it is not
frozen.
Drill bit 0.076” or 1.93mm
for the trimmer hole
