Smart Resource Booking Technology
www.resourcexpress.com
16
Solid or Partition Walls
1.
Using a suitable spirit level, where the screen is to be located, mark the position where
the bracket is to be located with a marker pen. The recommended height to the centre
of the screen from the floor level is 1500mm
9.
If the bracket has been supplied separately to the screen, separate the bracket into its
two halves and fix the half shown below to the back of the screen using the 4 off M4 x
5mm pan head screws supplied.
2.
Place the other half of the bracket to the mark in step 1 and mark four fixing hole
positions onto the wall.
3.
Drill suitably sized holes for wall plugs supplied (see guide supplied with bracket - cavity
wall plug not supplied) and fit wall plugs.
4.
Using the four pan head screws supplied fix the bracket half to the wall.
5.
Align the retaining tabs with the outside edges of the bracket half fixed to the wall and
slide the screen down until it sits on the stop tabs.
6.
Making sure the screen is still level, hold it firmly whilst tightening the 2 x M4 screws
on the underneath of the bracket.
7.
Finally attach the power cable and plug in, once finished cover the cable in protective
trunking, if required.
Image showing rear of screen, wall side bracket half & wall fixing holes
