PART VI HOW TO REPLACE THE PARTS
6-7
ENGLISH
6.5 REPLACE THE DISCHARGE SWITCH
When you replace the discharge switch, proceed with the following steps.
- Stop the operation and unplug the power plug from the electrical outlet.
- Open the bottom plate.
- Discharge the unit high and low voltage contact terminals by
creating a short circuit. If not, an electrical shock may occur (See the
below picture).
- Unplug the black voltage wire from the discharge switch.
- Unplug the ground wire from the discharge switch.
- Open the screw in side the unit.
- Push down the switch as you pull out the discharge switch.
Phillips
screwdriver
Required tools
1. Lay down the unit horizontally
with unit bottom led facing toward
you. Unscrew the 10 screws
located on the bottom of the unit
with Phillips screwdriver.
2. Unplug the black
voltage wire connection.
Do not hold the wire
when you unplug the wire
connection.
3. Unplug the ground wire
connection. Hold the
connection tightly when you
disconnect the connection.
4. Open the screw located on
the discharge switch inside the
unit. In some units, there are 2
screws on it.
5. Push down the switch as you pull out it from the bottom.
Create a short circuit between low
voltage terminal and ground terminal
with screwdriver.
Create a short circuit between high voltage terminal and a
screw on the bottom with screwdriver.
WARNING
To reduce risk of electric
shock, it is extremely
important to discharge the
high and low voltage contact
terminals before touching
them.
When you change the
discharge switch, simply do
the reverse operation. Make
sure each connection is
connected tightly.
Summary of Contents for R200T
Page 69: ...ENGLISH NOTES ...