6
Fitting Gloves Into The Respirex Locking Cuff
1.
Firstly turn the sleeve of the garment inside out.
2.
Carefully push the tapered cone into the glove so that the glove stretches over the cone (see Figs 2 & 3).
Fig. 2
Fig. 3
3.
Push the glove and cone into the cuff body with the little finger of the glove in-line with the seam of the
sleeve (see Fig 4).
4.
Make sure that the glove and cone are pushed into the cuff body with equal pressure all around its
circumference (see Fig 5).
Fig.4
Fig.5
5.
Locate the locking ring over the gauntlet of the glove and screw into the cuff body (see Fig 6). If
necessary the gauntlet of the glove can be cut down if it is too long and interferes with the locking ring.
Fig.6
Fig.7
6.
Turn the sleeve the correct way out by pulling on the glove (see Fig 7).
Check that there are no creases in the glove around the cuff seal. If there are any creases or the glove is
pinched in any way it should be removed and re-fitted. If the cuff and glove have been assembled as described
there should now be a gas tight wrist seal.
