www.response-technologies.com
- 17 -
©Response Technologies, Ltd.
Revised: January 9, 2015
Section 5
Console Configuration
Message Repeat
Message Repeat
field is used to set the desired amount of repeats (0-5) for the verbal message to
be annunciated upon sensor activation. Repeats are in addition to the standard message (one
repeat will play message twice).
Message Repeat Delay
field is used to set the desired amount of time (0-10 seconds) between
message repeats.
Radio/Speaker Volume
Use the slide bar to set the desired output volume over the radio and/or speaker.
SYSTEM CONFIGURATION
Verbal Prompts
The system is programmed with verbal prompts to assist user with menu navigation. This
section enables the user to turn on/off verbal prompts (i.e. “
SCOUT
Armed”, “Sensor Linked”
).
Battery Notify
The
SCOUT
is programmed with verbal notifications of internal back-up battery status (i.e.
“
SCOUT
battery low”
). This section enables the user to turn on/off battery notifications. These
notifications are transmitted via user’s radio system, paired cell phone, or speaker.
This notification is only for the internal battery of the main
SCOUT
unit; not sensors.
Entry/Exit Delay
Entry Delay
field is used to set the delay (0-99 seconds) for all sensor activations. This delay is
intended to allow the user time to disarm the
SCOUT
prior to notification of sensor activation.
Exit Delay
field is used to set the delay (0-99 seconds) for
SCOUT
to ARM from the time the
SYSTEM ARMED/DISARMED key is pressed. This delay is intended to allow the user time to
exit the premises before the
SCOUT
becomes active.
Output Relay
Select the output relay latch setting desired. The
System Disarmed
option will create a
continuous latch until the system is disarmed by the user. The
Relay Latch Time
option will
latch a single time for the amount of time specified.
