35
34
（1）
（2）
Method of usage
Method of usage
3
3. Insert the rotating inner sleeve and the rotating outer sleeve into the left side of
the calf and the right side of the lower leg (note: the large step must face inward)
(Figure 3).
4. Open the calf support hinge cover on the left and right mounts of the massage
chair (Figure 4).
4
5
6
·
Then hang the lower leg (left and right shaft) into the frame support hinge plate at
the same time(figure 5).
·
Cover rotating shaft cover, press calf rotating cover, and then tighten calf rotating
cover board with two M5×14-12.9 screws and a 6×12×1.5 flat pad by supplied 4#
hex wrench. (Fig. 6)
7. After the screw is locked, insert the rear slot of the calf cover into the pin, and
then press the front end of the calf cover down and the rotating shaft. the cover is
completely parallel and the calf is installed (Figure 7)
7
9.Head cushion and backrest pad's dismounting and use manual
·
Using head cushions can reduce the kneading massage intensity on neck
andshoulder, according to your needs to decide whether the head cushions
isneeded (recommend head cushions). Backrest cushion and backrest connected
by zipper (1), head cushions and backrest pad connected by thread gluing (2).
Zipper
Thread gluing
