Restoration Hardware 26100040 Assembly Instructions Download

Page: 3 / 4

To Light:

- Light the gel fuel with an

extended lighter or long match

- Burn time will be approximately

2 to 2.5 hours.

To Extinguish:

- Place the snuffer end of the

scraper tool (3) over the opening

on the Burn Cup. Hold in place

for 5-10 seconds until flame is

extinguished.

Step Three

Step Two

With the cup placed in burner; open the lid and fill with

Restoration Hardware approved gel fuel.

Fill the cup to a maximum of 3/4” from the lip of the cup.

¾”

Pour

Gel

Do not fill past

this point

Summary of Contents for 26100040

Page 2: ...Burn Cup 540 1 3 Scraper Snuffer 540A 1 4 River Rock 527 1 Bag 2 3 4 1 Step One After unpacking all parts and removing all plastic place the Burn Cup 2 back into the hole in the center of the burner Spread the river rock evenly in the area around the burn cup River Rock 2 4 ...

Page 3: ...nuffer end of the scraper tool 3 over the opening on the Burn Cup Hold in place for 5 10 seconds until flame is extinguished Step Three 6 3 Step Two With the cup placed in burner open the lid and fill with Restoration Hardware approved gel fuel Fill the cup to a maximum of 3 4 from the lip of the cup 5 Pour Gel Do not fill past this point ...

Page 4: ...aned every two burns This can be cleaned with the snuffer tool included Allow can to cool completely before attempting to clean Place the straight edge of the scraper into the can and pull along the edge Residue should be thrown away in the trash ...