11. Battery Save Mode
To set “Battery Save Mode”, please use programmable
software to set the selection.
Note: a. Blank means the transceiver is not in battery save
mode.
b.Making Tick means the transceiver is not in battery
save mode.
12. Battery Voltage Prompt
Note: Battery voltage too low: when battery voltage is
low to a certain level, if “Voice Prompt Selection” is off, then
the transceiver will prompt “Beep Beep” sound every 15S. If
“voice Prompt Selection” is on , then the transceiver will
prompt “Please change battery”. If “Voice Prompt
Selection” is selected on English / Chinese, press PTT button
or use VOX function both do not work and the transceiver is
prompting “Please change battery”, and also “Beep”
sound until release PTT button or finished VOX function.
13. Busy Channel Lockout
If BCLO function has been set, then if press PTT button
when receiving signal, the transmitting is prohibited, and keep
beeping until release PTT button.
14. Wide/Narrow Bandwidth Selection
The default bandwidth is “Wide”,users can choose Wide
band(25KHz) or Narrow band(12.50KHz) at present working
channel.
15. VOX
1.VOX function frees your hand without pushing PTT button
for transmission. It uses voice to transmit , when voice stops
then transmitting stops automatically. Users can use
programmable software to ON/OFF this function .
a.When VOX function is on at your transceiver channel.
Speak to microphone, transceiver will transmit your voice
automatically.
When stop talking, transceiver will stop transmit and wait
for receiving.
b.When you are also wearing headset.
To use VOX function, the VOX gain must be adjusted.
Setting VOX gain to let transceiver to recognize the level of
voice volume.
If microphone sensitivity is too high, then any noise
around will let the transceiver starts transmitting
automatically .
If microphone activities is too low, then the transceiver can not pick
up your voice. So to make sure the communicable works , the VOX
gain must be adjusted at a correct level.
12
13
