Battery information
■ Accessories installation
DIGITAL TWO WAY RADIO
DIGITAL TWO WAY RADIO
charging. It is recommended that the new battery be operated as above
for the first three uses. When you find the battery power is low, you
need to charge the battery.
● Suitable battery type
Please use the specified battery for charging; use of other batteries may
cause explosion, resulting in human injury.
● Battery safety attention
1.Do not allow metal contacts (including coins, keys, jewelry, or other
conductive metal) to be touched by the battery contacts or pole pieces.
Otherwise, the battery may short circuit, discharge, heat or leak, which
may result in damage to the item or personal injury. Therefore, be
careful when handling any battery.
2.Do not short-circuit the battery terminals or discard the battery in a
fire. Do not disassemble the battery pack. When the battery is
discarded, please put into a dedicated battery recycling box.
● Battery normal operation instructions
★
Please charge the battery indoors, battery charging at room
temperature best.
★
Under normal circumstances, the charger indicator from red to green
when the battery is fully charged, at this time the battery can be
removed.
★
You can charge when Battery installed in the walkie-talkie, but when
charging is best to turn off the walkie talkie, to ensure that the battery is
fully charged.
★
Please do not charge the battery when the battery power is not used
up (after the battery is exhausted, the voice prompt alarm will be given),
which will shorten the service life of the battery.
★
Do not put a fully charged battery back on the charger to "power up"
again, as this operation significantly reduces the cycle life of the battery.
●Extend battery life
★
Battery performance will reduce below -20
℃
temperature conditions.
Prepare back-up batteries for use in colder weather. Please do not
throw away cold batteries that cannot work. These batteries may be
used at room temperature.
★
Dusting the battery contacts may affect the battery life. Please wipe
the contacts with a clean, dry cloth before inserting the batteries into the
walkie-talkie.
● Battery storage needs to know
1.Since the battery will have a self-discharge phenomenon, the battery
when not in use for a long time, please fully charge the battery and then
stored to avoid over-discharge of its battery to damage the battery.
2.When the battery is in storage, remove the battery to recharge when
stored about 6 months. To avoid over-discharge of electrolyte affect
battery capacity.
3. Pay attention to the temperature and humidity of the battery storage
environment. Store the battery at room temperature in a cool, dry place
to minimize self-discharge of the battery.
If the dealer has set the
【
battery power prompt
】
shortcut key for the
product, you can press the shortcut key to check the remaining battery
power by voice prompt:
1
．
Install / remove the antenna
Turn off the radio and insert the antenna into the mounting hole and turn
clockwise.
When removing the antenna, turn it counterclockwise to remove the
antenna.
Do not shake the top of the antenna by hand, otherwise it will
reduce the working performance and service life of the antenna.
2
．
Install / remove the battery
● Install the battery
Battery Power
Battery power is sufficient, Battery Voltage ≥3.8V
Battery power is normal,Battery Voltage about
3.7V
Battery power is low,Battery Voltage ≤3.6V,If the
battery voltage is lower than 3.5v, transmission is
prohibited, but reception is not affected. Please
charge or replace the battery as soon as possible
Voice Prompt
High Power
Medium Power
Low Power
09
10
