OPERATING MANUAL FOR
RETIGO
HOLD-O-MAT
8
ver. EN-01/10/12
6.
Operating of Retigo Hold-o-mat 1/1 Standard
(with temperature core probe)
6.1 Control panel
6.2 Basic operating instructions
Basic operating instructions are consistent with
chapter 5. in this operating manual.
6.3 Programing with core probe functions
6.3.1 „Hold with core temperature information“
function
In the Hold function, you can switch the core
temperature sensor on or off as an informative
monitoring instrument by pressing button
briefly.
The displayed temperature corresponds to the
measured value which the tip of the sensor measures
(single-point sensor). If the sensor is stuck into meat,
the existing core temperature is displayed, otherwise
the room temperature, which however may differ by a
few degrees from display 4 (Room temperature display).
If the sensor is defective or not plugged into the
device, the information „dEF“ appears in the display 5
(core temperature or time display). In this case, it is still
possible to use the Hold-o-mat, but without the core
temperature sensor.
In the „Hold with core temperature information“
function, the display 6. is used only for information. The
core temperature sensor does not regulate the device,
and there is no signal tone.
6.3.2 „Cook & Hold with fully automatic cooking
phases“ function
Hold-o-mat with temperature core probe contains 10
preset programs with 3 steps.
Programmes 1 to 5 are programmes which can be
changed immediately, and give you the phase with
which you want to work. Preset values of these
1. Main switch -on/off
2. Lower
temp.
3. Higher
temp.
8. Start
(For Cook&Hold
programs only)
6. Core temp. or
time display
4. Room temp. display
5. Heat
indicator
7. Function button:C&H
or core porbe
programes could be found in chapter 6.3.3.
Programmes 6 to 10 are free programmes, which
you can assign as you wish. Preset values of these
programs could be found in chapter 6.3.3.
In the case of programmes 6 to 10, to prevent an
unintended programme change being made on viewing,
before the change a release must take place by the two
buttons
being pressed simultaneously.
If you want to remove a phase, just go to a
temperature value below 20° in the appropriate phase,
and the phase is removed (in both displays, „- - -“
appears).
When a programme has ended, the buzzer sounds
for one minute and then stops.
The Hold-o-mat remains in the „hold position“ in the
last phase. If the core temperature overshoots, this is
displayed from 1 °C higher and the display with the core
temperature begins to flash.
Programování
By a long press (2 seconds) on button
, you
change to Cook & Hold mode.
1. Pr 1 appears on the displays. Using buttons
you can switch between programmes 1 to
10.
2. Once you have selected the programme you want,
you can start it by using button
. To change a
programme, select your programme number. By
pressing button
briefly, you switch to changing or
viewing mode. In all cases, the flashing display can
be changed; the flashing dot informs you which phase
you are in. By pressing button
twice, you finish
values changing and jump to the next setting.
If you press buttons
simultaneously, the
device gives you a reference value (default value), so
that you do not have to begin each entry at zero.
