11
Operating
Operating the radio controlled Clock
After inserting the battery, the clock
automatically
will start the
initializing procedure. The display is set to zero and the clock
starts receiving the transmitted time signal. Do not reposition the
clock during this reception and setup process. During the recep-
tion process, the reception indicator (13) flashes on the dis-
play. A few minutes later the current time and date are shown on
the display.
Briefly press the signal receiving key (2) to manually enable the
signal reception mode
. The reception indicator (13) flashes
on the display. A few minutes later when the reception process is
finished, the current time and date are shown on the display.
Press and hold the signal receiving key for 3 seconds to termi-
nate this process prematurely.
If no signal can be received, the time can be
setup manually
.
Press the set key (3) for three seconds to enter the setup mode.
The 12/24 hour display flashes. Use the up and down keys (5)
and (6) to setup the flashing digit. Use the set key (3) for confir-
mation and to skip to the next item in the following sequence:
12/24 hour format, time zone, hours, minutes, year, month, day,
language. After confirming the language, the setup mode is fin-
ished.
Notes:
The time will be adjusted automatically when the time signal is
received at a later time.
If no key is pressed for 30 seconds during setup, the setup mode
automatically will be quit.
Keep the up or down key pressed to change the flashing value
more rapidly.
The country codes during language setup:
EN
: English
GE
: German
