RETRO EMRX, Owner'S Manual

This device complies with part 15 of the FCC rules. Operation is subject to the following two (2) conditions:

(1)

  This device may not cause harmful interference, and

(2)

  this device must accept any interference received, including interference that may cause undesired 

operation.

Note: 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more 

of the following measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver.

• 

Connect the equipment into an outlet on a circuit different to that to which the receiver is connected.

• 

Consult the dealer or an experienced radio / TV technician for help.

Do not make any changes or modifications to the equipment unless otherwise specified in the manual.

FCC COMPLIANCE STATEMENT

ELECTRICAL GROUNDING

AQUA/LAMP® is registered trademark of Consolidated Pool & Spa Industries Inc Canada. 

Spa Electrics Export Pty Ltd Australia and it’s ATOM and RETRO brands are not affiliated or endorsed by these companies and/or their brands.  

Underwriters Laboratories (UL) Statement

Per the NEC, NFPA 70, Article 680.23 (B)(5), states that bonding shall not be required 

for luminaires that are listed for the application and have no non-current carrying metal 

parts. In addition, per Article 680.26 (B)(4), exception states that Listed low-voltage 

lighting systems with non-metallic forming shells shall not require bonding. 

Therefore, luminaires with polymeric/non-current carrying metal parts 

are not required to be grounded / bonded.

Manufacturers Statement

Spa Electrics ATOM & QUANTUM (EM & WN9) luminaires with their plastic housing 

designs and plastic niches do not require grounding / bonding.

Spa Electrics ATOM & QUANTUM (EM & WN9) lights have also been determined 

to comply with the applicable requirements for wet-niche, LED type Swimming Pool 

and Spa Luminaires.

13