3
INTERNAL CLOCK
SSH
SSH Users Manual
retroaktiv
Figure 2 - SSH Block Diagram
INTERNAL CLOCK
The built-in clock generator determines the interval at which the sample and hold
generator samples incoming signals. The clock ranges from about .25Hz to 100Hz. The
minimum rate of the clock can be set by the MIN RATE trimmer located on the rear of
the module. The rate of the clock can be controlled with external CV (+5v to -5v signals
recommended.) External CVs can be attenuated using the CV (RATE) knob.
The internal clock is normalized to the S&H trigger input via the TRIG jack. When a
cable is inserted into the TRIG jack, this connection is broken, and the S&H generator
will be clocked by the external trigger signal. External trigger signals should be a pulse
such as those from a typical LFO. (3vpp minimum. Input tolerant of pulses 10vpp)
