Rev-A-Shelf RV 35 QT Series, Installtion Instructions

2

Customer Service: 

800-626-1126 | rev-a-shelf.com

I-RVKDRB-1018

FIG. C

FIG. D

#2

#2

#2

#2

#2

#2

Attach both uprights into the 

tubes located on the frame 

(See 

Figure C)

. 

Finally attach the optional handle 

and insert the waste container. 

Note: Handle should only 

be used if you are not using 

the optional Rev-a-shelf door 

mounting kit (sold separately).

Begin by setting the frame inside 

the cabinet. Locate the position 

of where you would like it to be 

mounted. 

Note: Look to make sure that 

there is no interference with  

the cabinet door when opening 

and closing.

STEP 1

With the frame securely in place, 

slide the frame out of the cabinet 

and remove the (2) pre-installed 

screws on the rear of the frame. 

The rear basket can be installed 

using these (2) screws  

(See Figure B)

.

Note: For 16” depth or shorter 

applications, the rear basket can 

be left off . 

STEP 2

With the frame in the closed 

position, insert the front (2) #8 x 

3/4”screws, making sure that the 

frame is square to the front of the 

cabinet. Then install the (2) #8 x 

3/4”rear screws 

(See Figure A)

.

STEP 3

FIG. A

FIG. B

STEP 4

STEP 5