9
GB
LED Arbeitsleuchte Bright 20W + 30W + 50W
Assembly and operating instructions
INTRODUCTION
Dear Customer,
We’d like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.
PROPER USE
• The product conforms to the appropriate European CE directives (S2).
• This product conforms to the appropriate European safety standards.
• The product is spray-protected, IP54 and suitable for outdoor use.
• The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
• The product may only be used only for the purpose for which it is intended, in accordance with this user manual!
• The product is not suitable for rough use (e.g. construction sites)!
• The product is not intended for use by persons (including children) whose physical, sensory or mental abilities
are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!
• Make sure that this product is kept out of the reach of children or unauthorised persons.
GENERAL INFORMATION
• Handle this product carefully. It can be damaged by shocks, blows or by being dropped, even from a low height!
• Disconnect the product’s mains power plug in the event of a fault during operation.
• This product has no replaceable parts. Do not attempt to open or repair this product!
GENERAL SAFETY INSTRUCTIONS
• Please observe the technical specifications!
• Please follow this instruction manual and keep it in a safe place!
• Please pass on this instruction manual to a subsequent owner!
• Not to be used by children!
• Do not operate a defective product!
• Never look directly into the LED light source! The light spectrum transmitted may contain blue components (S3).
• Always allow to cool down sufficiently and for cleaning purposes disconnect the luminaire from the power supply
and secure the electric circuit against being switched on again.
• Must not be used in areas that represent an explosion hazard (e.g. carpentry workshop, paintshop, or similar)!
• Do not use in the immediate vicinity of flammable materials!
• Do not install in the immediate vicinity of paddling pools, fountains, ponds or similar bodies of water.
• Do not immerse in water or other liquids!
• The light source in the luminaire is not replaceable. The entire luminaire must be replaced at the end of its
service life!
• Always install at least 1m away from illuminated surfaces — the connection cable in particular must not be
illuminated or come into contact with the metal housing — and observe the required minimum distances (S4)!
• Do not operate the product when covered (S5). This could lead to a dangerous buildup of heat!
• The product must remain freely accessible (also when in use)!
• For the connection, only use regular mains sockets (230V~, 50Hz) with protective conductors of the public
supply network which are easily accessible!
• Do not open the housing!
• A conversion or modification of the product affects product safety. Caution: risk of injury! A conversion or
modification of the product must not be carried out!
• If the cable is damaged, disconnect product from the power supply!
• De-energised only when the plug is pulled out (S6)!
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• To avoid damage, do not bend or knot cables over sharp edges or corners!
