10
GB
•
Dimming
: briefly tap the area next to the sensor until the desired dimming level is reached
•
Colour change:
tap long on the area next to the sensor until the desired colour temperature is reached
• If you connect a second under-cabinet light of this type via the connecting cable, you can adjust and control both
lights separately and independently.
•
Memory function:
the last selected setting is available again the next time you switch on
•
On/Off:
wipe over the sensor at a distance of max. 5cm
• Never combine more than the three products contained in the delivery.
• Only connect devices up to max. 24W total power!
• Note the cable length of the products (approx. 1,5m) and the power supply unit.
• To avoid damage, do not bend or knot cables over sharp edges or corners!
• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• Do not operate the product’s buttons with electrically conductive objects!
• Coverage area: max. 5cm
• IP protection class: IP20
TECHNICAL DATA
• Standby consumption: 0,3W
• Colour temperature: 3000K-6500K
• Protection class: III (S9)
• Output: 10W LED
• Colour rendering index (Ra/CRI): ≥ 80
• Power supply unit: 230V~; 50Hz; 0,5A // Output: 12V AC; 2A; 24W // Protection class: II (S8)
• Ambient temperature: 0°C - 35°C / max. 35°C
• Illuminant: 60 SMD LED´s
• Energy efficiency class: A
• Dimensions W x H x D: 550 x 44 x 25mm
• Luminous flux: max. 730lm
• Light output: max. 73lm/W
• Dimming mode: 25% / 50% / 75% / 100% adjustable in 4 steps
• LED service life: 25000h
• Nominal values: 230V~; 50Hz
• Coverage angle: 5°
• Beam angle: 120°
• Accessories (Connection cable)
• Product
• Mounting material (Screws, retaining clips)
• Instructions
• Power supply unit
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
SCOPE OF DELIVERY
CLEANING
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
INSTALLATION (B2)
FUNCTION (C3)
• Please refer to the drawings for the installation steps.
