background image

Startup

1. Detach cover and unscrew frame.

2. Connect receiver according to connection  

   drawing.

3. Fasten receiver to switch box with two  

   box-screws.

4. Mount frame and cover again.

To set-up article  0086160103, a iComfort rocker set 

with suitable frame is needed.

Teaching

•  All receivers must be programmed onto the  

 

  button to which it is meant to react.

1. The programming mode is activated for about   

   1 minute by pushing the „LEARN“ button of  

    the product for about  2 seconds. Thereby the  

   red LED is flashing with a frequency of 1Hz.

2. Now the device must be chosen on the  

   remote control and transmitted to the receiver by  

   pushing the „ON“ button or  operation the rocker  
   switch. 

 

Group membership

 

Decide wheter the switch power socket is to react 

to a group call (device group 0). (See switch on the 

backside)

Only in combination with remote control type  

84471-B.

ON  

Must react

OFF 

Must not react

Switching without remote control

At the receiver 

•  open/close shutter: press rocker

•  stop shutter: press rocker button again

Technical data

•  Range: 100m (free field) 

•  Supply voltage: 230V~, 50Hz

•  Power: 500W

•  Inductive load: 500VA (cos(phi)=0,8)

•  Fuse: T6,3A H 250V~ (non replaceable)

•  Frequency: 868MHz

•  Own power consumption: <0.5 Watt

•  Number of device groups: 1

•  Number of devices per device group: 10

•  Pollution degree: IP20

•  Ambient temperature: T25°C

CE Declaration of Conformity

Hereby REV Ritter GmbH declares that 

model/ serial 84479-B conforms to the 

basic requirements and remaining, 

applicable provisions of DIRECTIVE 

2014/53/EU OF THE EUROPEAN 

PARLIAMENT AND OF THE COUNCIL of 16 April 2014 

on the harmonisation of the laws of the Member 

States relating to the making available on the market 

of radio equipment and repealing Directive  

1999/5/EC . Please see below for a complete CE  

conformity declaration: www.rev.biz under the  

relevant  item/item no.

WEEE-reference of disposal

In accordance with European defaults used 

electrical and electronics devices may no 

more be given to the unsorted waste. The 

symbol of the waste bin on wheels refers to 

the necessity of separate collection. 

Please help with environmental protection 

and see to it that this device is given to the for this 

purpose designated systems of waste sorting if you 

do not use it any longer.

DIRECTIVE 2012/19/EU of the EUROPEAN  

PARLIAMENT AND OF the COUNCIL of 4 July 2012 on 

waste electrical and electronic equipment (WEEE).

Warranty

During manufacturing this REV product is passed 

through several quality testing stations which are set 

up with newest technology. Should nevertheless a 

defect arise, REV offers a warranty to the following 

extent:

1. The duration of the warranty is 24 months after the  

  date of purchase.

2. The unit is either repaired or replaced by REV free  

  of charge or if it can be shown that it has become  

  unusable during the warranty period due to a  

  manufacturing or material defect.

3. The liability does not cover transport damages or  

  damaged incurred through defective installation. 

4. If  REV repudiates the warranty claim and no  

  objection is made within 6 months, the right to  

  repair becomes time-barred.

5. In a warranty case the unit must be sent to the   

  dealer or REV together with the sales slip and a  

  short description of the defect. 

6. If there is no proof for a warranty liability being in  

  place, any repair carried out will be invoiced.

ENGLISH

868MHz

REV Ritter GmbH • Frankenstr. 1-4 •  D-63776 Mömbris

Tel. +49 900 117 1070 •  E-Mail: service@rev.biz • www.rev.biz 

*(0,36€/Min. aus dem deutschen Festnetz, Mobilfunk abweichend)

ANL_84479-B.indd   4

30.06.2016   10:34:44

Summary of Contents for iComfort 84479-B









Reviews: