Revamp CL-2000, User Manual

C

FRONT

BACK

D

B

A

E

•  Thread the hair through the small recess at the front of product, then down through 

the deeper aperture at the back of the product as shown in (

C

). Hold the appliance 

around 50-75mm away from your head. (

A

)

•  Choose the direction of the curl by pressing the right or left curling button (feature 2) 

as shown in diagram 

D

. Work on one side of the head at a time. When you move on to 

the other side, press the opposite direction curling button 
so that your curls are symetrical (

D

).

•  VERY IMPORTANT

 - Please do not put your fingers in the 

deeper aperture at the back of the product or try to touch 
the hot barrel.

•  Press and hold the curling button and the hair will be 

automatically wrap around the heated barrel. 

•  Keep holding the button while the hair is wrapped around 

the barrel and until you hear the beep. 

•  The curling system stops and a beep is heard after 10 

seconds which is sufficient time to curl normal hair.

•  After hearing the beep, release the button and wait for the barrel to stop rotating 

before lowering the appliance from the hair to release your curl. 

•  Caution!

 When the curling mechanism has stopped, always pull the product downwards 

to release the curl. 

•  Repeat for each hair section, allowing each curl time to cool in between.
•  After use, switch off the appliance, unplug and allow to cool before storing away.

•  THE PRODUCT MAY JAM IF TOO MUCH HAIR IS FED AROUND THE BARREL. 

In this case, the 

product will automatically shut off. Simply pull product down to release the hair and 
turn back on again to continue using.

Follow us on www.revamphair.com for the latest hair tips and advice.

Please note:

•  To prevent hair damage, do not curl the same section of hair more than twice 
•  As with all heated appliances, avoid frequent use to prevent damage to the hair
•  Avoid over-use of styling products as this may deteriorate the coating on the barrel. 
•  The heated barrel and top end of the appliance gets very hot during use. To avoid burns, 

keep the barrel away from direct contact with the head and only hold the appliance by 
the handle. 

•  While heating, during use and cooling, place on the REVAMP heat-resistant mat. Only 

hold the product by the cool handle.

•  Do not scratch the surface of the curl barrel as this will deteriorate the effectiveness of 

the coating.

•  The product reaches a very high temperature during operation, please style with 

caution when using. Make sure to keep away from the scalp and skin to avoid burns.

AUTO SHUT-OFF

This appliance has an automatic shut off feature for added safety. If the appliance is 
switched on for more than 30 minutes continuously, then it will automatically switch off. If 
you wish to continue using the appliance after this time, press the power button to switch 
on. Use the temperature control to select your desired temperature. 

This feature should not be considered as a substitute for ‘OFF’. ALWAYS REMEMBER TO 
SWITCH THE APPLIANCE OFF AND UNPLUG FROM THE MAINS WHEN NOT IN USE.