3
Charging Procedure
Driving the Vehicle
Getting Started:
Operation:
2. Switch the car to ON.
The ESC will «BEEP» 4 times
if the controller is not on.
1. Turn the controller on by
pressing the button.
To turn the controller off,
press and hold the button
until the blue light turns off.
Attention:
•
Allow the battery to cool off for 10-15 minutes before recharging.
•
Do not leave the battery unattended during the charging process.
•
The car can be driven for approximately 6 minutes following a charge time of approximately 2 hours.
• Charge times will vary depending on how much charge is left in the battery.
5. Disconnect the battery from the charger and
reconnect the battery to the speed control.
4. The charging process takes approximately 2
hours. For safety reasons, never charge the battery
for longer than 2 hours. While charging, the peak
detection unit LED will be on. When the battery is
fi nished charging, the LED will be off.
1. Switch off the car.
2. Carefully connect the battery to the peak
detection unit.
3. Plug the other end of the charger into an AC wall
outlet.
• To slowly drive forward, pull the trigger slightly. To drive
faster, pull the trigger further.
• To brake, push the trigger. To drive in reverse, push again.
• During a crash, release the trigger.
• To turn, rotate the wheel to the left or right.
• Always move the controls slowly and with a gentle touch.
• When the vehicle battery becomes low, the vehicle will roll to a stop and the motor will begin beeping.
• Allow the battery to cool before recharging.
RMXC3968 Instr.indd 3
6/21/2013 8:16:46 AM
