REVELL NANO Hexagon, Manual

6

FLIP MODE

LOW BATTERY INDICATOR

SENSOR CALIBRATION

After the Nano Hexagon has been flying for about 6 minutes, the LEDs on the arms will flash. This is a warning to land and charge the battery as 
soon as possible. Always charge the battery when the flight is completed. When the LEDs are flashing, the Nano Hexagon will not have enough 
power to perform a flip. 

Remember to ALWAYS turn off the Nano Hexagon after flight!

If your Nano Hexagon will not hover in the same spot when the right stick is 
centered, the sensors may need calibration. 

1. Place the Nano Hexagon on a level surface. 
2.  Center the trim adjustments. The controller will make a long beep when the 

trim is at the center position.

3.  Change the control sensitivity to the Expert Setting (page 5). Move both 

sticks to their lowest position and to right as far as possible. The LEDs on the 
hex will flash for a few seconds while the sensors are being calibrated.

ON  

OFF

The Nano Hexagon has a built in flip function. When the right stick is 
pressed down, the TX will make a short beep to indicate it is in the flip 
mode. When the right stick is moved, the Nano Hexagon will flip in the same 
direction.