4. If you plan to install the spiked feet, perform the instructions in
the section below, Installing Spike Feet.
5. If you don’t use spikes, roll the subwoofer onto its bottom and
remove the top pad. Use caution to avoid scraping the finish or
pulling off the grille.
INSPECTING THE REVEL PERFORMA B15
SUBWOOFER
After unpacking, carefully inspect the REVEL PERFORMA B15
subwoofer for possible damage due to shipping. If you discover any
damage, immediately contact your Revel dealer for further assistance.
Keep all packing materials for future shipping. In the unlikely
event a product will need repair, Revel will only accept a unit in its
original shipping carton. Using any other packing materials may
result in damage to the product and is not covered by the warranty.
See Obtaining Service on page 25 for additional details.
INSTALLING SPIKE FEET
1. Remove the spike feet, covers, lock nuts, and wrench from the
plastic bag.
2. Remove the three black screws that serve as glides and store
them for future use. Start a set of spikes, as shown in Figure 4
(on the next page). Be sure to thread each spike the same
amount to achieve a level placement.
NOTE: If the subwoofer is to be used on a hardwood or tile floor,
use the round ends with optional supplied covers. Further adjust-
ment of each spike may be necessary due to uneven floors.
3. Using the supplied wrench, tighten a lock nut onto each spike.
4. When finished (see Placement on page 11), turn the REVEL
PERFORMA B15 subwoofer upright and remove the top pad.
Continued on the next page...
REVEL PERFORMA B15
Owner’s Manual
9
