Operation and Maintenance Manual – Steam sterilizers mod. Full Clave
Rev. 01 of 01-12-2006 - C:\Documenti\Manuali di istruzione\FULL CLAVE GB-R01.doc
Page 30 of 34
Via Don Luigi Sturzo n°6
42021 BARCO ( Reggio Emilia ) ITALY
Tel. 0039 ( 0 )522 / 875159
Fax 0039 ( 0 )522 / 875579
FORM TO FILL OUT WHEN
APPLIANCES ARE
RETURNED FOR REPAIRS
To be filled out by the:
Installer or authorized person
Autoclave mod
…………………………………………………..….…
Serial N°
……………..………………………………………………....
At
…………………………….………………………………………………………………………………………………………………………………….
Situated in
………………………………………………
address
………………………………………………………………………………………….
Purchase invoice N°
………………..…………………………………………………..
of
…………….….…….……………………………………..
Issued by Company
……………………………………………………………………………………………………………………………………...
Date of first installation
……………………………..
by Mr.
…………………………………………………………………………………….…
Was the warranty form sent to the manufacturer when appliance was first installed? yes no
Reason why the machine must be sent back to the Manufacturer:
PERIODIC CALIBRATION
REQUEST FOR REPAIR UNDER GUARANTEE
REPAIR SUBJECT TO PAYMENT
OTHER
………………………………………………………………………
FAULT ENCOUNTERED: Which message appears on the display?
………………..……………………………………………….
……………………………………………………………………………………………………………………………………………………………………….
……………………………………………………………………………………………………………………………………………………………………….
……………………………………………………………………………………………………………………………………………………………………….
……………………………………………………………………………………………………………………………………………………………………….
……………………………………………………………………………………………………………………………………………………………………….
BEFORE SENDING BACK THE AUTOCLAVE, PLEASE COMPLY WITH THE FOLLOWING
INSTRUCTIONS:
1.
Before sending back the machine, fill out this form and send it via fax to N° 0039 0522 875579 and send us
free of charges. In case of non accepted repair estimate, will be invoiced € 50,00.
2.
The warranty will become void if the machine is sent back without prior authorization.
3.
If possible, allow the machine to operate until the minimum level Led comes on.
4.
Empty the used water from the tank.
5.
Place a folded piece of newspaper between the door and chamber and then shut the autoclave to prevent
one of the two parts from being damaged during transport.
6.
Remove the tray-holder. Do not send it back with the machine.
7.
Send the autoclave packed in the original wrapping in which it was purchased.
8.
Install the substitute machine (if applicable) in compliance with the recommendations in the maintenance
manual.
The installer hereby declares that the indicated operations have been carried out, that the machine supplied
as a substitute has been installed in compliance with the instructions in the maintenance manual and that it
functions perfectly. The technician also declares that the form with the test results of the first installation
has been filled out and sent off along with the warranty form.
Date
……………………………………
Installer's signature
….………………………………………………….…
