Page 13
Polycom® Installation (Polycom HDX9000 shown for example)
This information is meant to be illustrative only. Consult your Polycom
Videoconferencing System Administrator Manual for specific instructions.
NOTE: Requires 2 special RCA Male to 3.5mm 3 pin connectors
Revolabs Part #07-POLHDX-01.
Step 1 Step 2
1. Plug the 3.5mm 3 pin cable into the Polycom video-station <Audio In 1 Red>,
and then plug the RCA connector on the other end into the Fusion Base
Station <Conf Out>.
2. Plug the 3.5mm 3 pin cable into the Polycom video-station <Audio Out 1
Red>, and then plug the RCA connector on the other end into the Fusion
Base Station <Conf In>.
To
configure the Polycom HDX 9000 Series system:
:
Select the button from the main screen to access the System menu.
Select the
System / Admin
settings.
Enter the administrator password and press
OK
(if needed).
Select the
Audio
settings.
Confirm or modify the following settings:
Input Type – Line Input
Input Type Level – 50%
Echo Canceller - OFF
Line Output Mode – Fixed
Line Output Level – 50%
Press
OK
to save changes.
Revolabs Fusion™
