12
12
12
12
Using the Revolabs Solo™ Wearable Microphone
1. Remove the microphone from the Charger Base. The microphones turn on and mute themselves
automatically when removed from Charger Base, to reduce noise while being attached to
clothing.
2. The wireless microphone has a clip on the back which allows
the microphone to be easily clipped onto a shirt pocket, blouse
or lapel. The microphone can also be clipped on to a lanyard
and be worn around the neck. Attach the microphone to
clothing or to a lanyard, as close to the mouth as possible
(within 6 - 12 inches is recommended).
3. With the microphone in the wearing position, un-mute the
microphone by pressing and releasing the
MUTE
button
(confirm by viewing flashing GREEN LED).
4. To turn microphones off, return the microphone unit to the
Charger Base or press and hold the
MUTE
button for ~10
seconds until the LED turns solid RED and release button.
5. If the microphones are moved out of range of the Base Station (~30 meters) the connection will be
dropped (LED flashes all colors) and the microphone will mute. After 15 seconds the microphone
will beep 5 times, and will continue beeping every 30 seconds to remind the user to return the
microphone to the conference room. If the microphone is moved back into range within 5 minutes
the connection will automatically be re-established to its original state, and the beeping will cease.
If not, the microphone will turn off after about 15 minutes.
Using the Revolabs Solo™ TableTop Microphone
1. Remove the microphone from the Charger Base. The microphones turn on and
mute themselves automatically when removed from Charger Base (flashing
RED LED), to reduce noise while placing the microphone on the table.
2. The TableTop microphone should be centered on the table in front of users,
between 2 to 5 feet (.75 to 1.75m) away. It is always better to be as close to
the person speaking as possible, but avoid placing the microphone where it
might be blocked by equipment or meeting paperwork.
3. With the microphone in position, un-mute the microphone by pressing and releasing the
MUTE
button (confirm by viewing flashing GREEN LED).
4. To turn microphone off, return the microphone unit to the Charger Base or press and hold the
MUTE
button for ~10 seconds until the LED turns solid RED and release button.
5. If the microphones are placed too far from the Base Station (~100 feet (30 meters)) the
connection will be dropped (LED flashes all colors) and the microphone will mute. After 15
seconds the microphone will beep 5 times, and will continue beeping every 30 seconds to
indicate that it is out of range. Move the microphone closer to the Base Station and the
connection will automatically be re-established to its original state, and the beeping will cease. If
not, the microphone will continue beeping until it turns off in about 15 minutes.
