3
EN
Transmitter
Frequency 2.4GHz
Battery
AA x 2
Servo
Power Supply
5V
Output Torque
0.8kg-cm @ 4.8V
1.0kg-cm @ 6V
Operating Speed
0.19 sec/60° of travel
Size
23 x 12.5 x 25mm
Electronic Speed Control (ESC)
Input Voltage
6–8.4V
Electric Capacity
20A
Size
68.5 x 32.5 x 22.5mm
Weight 32.3g
Vehicle Preparations ....................................................................................4
Charging the Vehicle Battery .....................................................................4
Charging Warnings ....................................................................................4
Binding .........................................................................................................4
Installing the Battery....................................................................................4
Transmitter Controls .....................................................................................5
Installing Transmitter Batteries .................................................................5
Getting Started.............................................................................................6
Operation......................................................................................................6
When You Are Finished................................................................................6
Motor Care ...................................................................................................7
Troubleshooting Guide .................................................................................7
Limited Warranty .........................................................................................7
Warranty and Service Contact Information .................................................8
FCC Information............................................................................................8
IC Information...............................................................................................8
Replacement Parts .....................................................................................17
Parts Diagram...................................................................................... 18–19
TABLE OF CONTENTS
COMPONENTS
SPECIFICATIONS
• Revolution
®
Seismic™ Monster Truck or Seismic™ Short Course Truck
• 2.4GHz Transmitter (ECX10003)
• 100mA 9V AC-Input Charger with EC3™ Connector (DYNC1030)
• 900mAh Dynamite
®
Speed Pack with EC3™ Connector (DYN1462)
• 2-in-1 Revolution
®
Receiver/ESC (RVOS11001)
• 370 Revolution
®
Brushed Motor (RVOS11000)
• AA (4) Batteries
QUICK START
Please read the entire manual to gain a full understanding of the vehicle, fine-tuning the setup and performing maintenance.
1. Read the safety precautions found in this manual.
2. Charge a battery for the vehicle. Refer to the included
charging warnings and instructions for battery charging
information.
3. Install the AA batteries in the transmitter. Only use alkaline
or rechargeable batteries.
4. Install the fully charged battery in the vehicle.
5. Power ON the transmitter and
then
the vehicle. Always power ON
the transmitter before powering ON the vehicle. Power OFF the
vehicle
before
powering OFF the transmitter.
6. Check the steering control direction. Verify that the servos are
moving in the correct direction.
7. Drive your vehicle.
8. Perform any necessary maintenance.
