6
EN
WHEN YOU ARE FINISHED
1.
Power off the receiver.
2.
Disconnect the battery.
3.
Power off the transmitter.
4.
Remove the battery from the vehicle.
5.
Recharge the battery.
1.
Power on the transmitter.
2.
Connect the battery to the receiver and power on the vehicle.
3.
Perform a test of the transmitter’s control of the vehicle with the
vehicle’s wheels off the ground.
4.
Start driving slowly, and, if the vehicle does not go straight, adjust
the steering trim dial on the transmitter.
IMPORTANT:
Seat the motor brushes by driving smoothly on a flat
surface during use of the first battery charge. Properly seating the
motor brushes will increase the life and performance of the motor.
GETTING STARTED
• ALWAYS
turn on your transmitter before you turn on the receiver in the
vehicle. Always power off the receiver before turning your transmitter off.
• ALWAYS
operate your vehicle in a wide open area. Operating the
vehicle in a small space or indoors can cause overheating at low speeds.
Operating at low speed increases heat in the electronic speed control
(ESC). Overheating can damage the vehicle and failure may result.
OPERATION
3
2
1
3
4
1
2
5
4
