7
EN
Limited Warranty
What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the
product purchased (the “Product”) will be free from defects in materials and
workmanship at the date of purchase.
What is Not Covered
This warranty is not transferable and does not cover (i) cosmetic damage, (ii)
damage due to acts of God, accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or maintenance, (iii)
modification of or to any part of the Product, (iv) attempted service by
anyone other than a Horizon Hobby authorized service center, (v) Product
not purchased from an authorized Horizon dealer, (vi) Product not compliant
with applicable technical regulations, or (vii) use that violates any applicable
laws, rules, or regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON MAKES NO
OTHER WARRANTY OR REPRESENTATION, AND HEREBY DISCLAIMS ANY
AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE
IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. THE PURCHASER ACKNOWLEDGES
THAT THEY ALONE HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY
MEET THE REQUIREMENTS OF THE PURCHASER’S INTENDED USE.
Purchaser’s Remedy
Horizon’s sole obligation and purchaser’s sole and exclusive remedy shall be
that Horizon will, at its option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective. Horizon reserves the right to inspect
any and all Product(s) involved in a warranty claim. Service or replacement
decisions are at the sole discretion of Horizon. Proof of purchase is required
for all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY.
Problem
Possible Cause
Solution
Short Run Time
Battery damaged/not charged
Check/change battery
Motor dirty
Check/clean
Sluggish Action
Motor dirty
Check/clean
Bind in drivetrain
Clean/adjust
Vehicle battery is not charged
Replace/recharge
Does Not Operate
Transmitter batteries low
Replace/recharge
Transmitter powered off
Power on
ESC powered off
Power on
Vehicle battery is not charged
Replace/recharge
Poor Range
Transmitter batteries low
Replace/recharge
Receiver antenna damaged
Check/repair/replace
The system will not connect
Transmitter and receiver too near each other
Move transmitter 3.3–9.8 ft (1–3 m) from receiver
Transmitter and receiver too near large metal
objects (vehicles, etc.)
Move away from large metal objects (vehicles, etc.)
Receiver accidentally put in bind mode so
receiver is no longer bound
Rebind transmitter and receiver
The receiver goes into failsafe mode
a short distance away from the
transmitter
Check the receiver antenna to be sure it is
not cut or damaged
Make sure the antenna is in the antenna tube
The receiver quits responding
during operation
Low battery voltage
Completely recharge battery
Loose or damaged wires or connectors
between battery and receiver
Do a check of the wires and connection between battery
and receiver. Repair or replace wires and/or connectors
Receiver and transmitter are not bound
Transmitter accidentally put in bind mode,
ending bind to receiver
Bind transmitter to receiver
Car does not drive straight
Steering trim on transmitter not centered
Adjust steering trim so vehicle drives straight
Servo failed
Contact Horizon Product Support
No throttle
ESC failed
Contact Horizon Product Support
Motor failed
Contact Horizon Product Support
Clicking noise in transmission area
Dirt or rocks in spur gear
Remove gear cover and inspect. If necessary, replace gear
Motor moved away from spur gear
Reset gear mesh
Troubleshooting Guide
• Seat the motor brushes by driving smoothly on a flat surface
during use of the first battery charge.
Failing to do so can
greatly reduce motor performance and functional life.
• Prolong motor life by preventing overheating conditions.
Undue motor wear results from frequent turns, stops and starts,
pushing objects, driving in deep water and tall grass, and driving
continuously up hill.
Allow the motor to cool completely
before running the vehicle.
• Over-temperature protection is installed on the ESC to prevent
circuit damage, but cannot protect the motor from driving against
heavy resistance.
MOTOR CARE
