Revox Audio Server
General settings
Revox Joy S37 Audio Server
Page 22
through the "Refresh rate" menu item.
You should only set the parameter if
there are display problems with picture
reproduction at a specific frequency.
Normally, this parameter is set
automatically between the picture
display device and the S37.
Audio settings
You match the audio output of your S37
with your amplifier through the Audio
setting menu. The S37 offers three audio
output options: analogue, digital optical
or HDMI. Make sure that the entry made
through this menu item matches the
actual cabling.
The factory setting for the audio
resolution sampling rates are 44.1 kHz
and 48 kHz. If your amplifier supports
higher sampling rates, you can also
select 96 kHz and 192 kHz. These settings
only affect the audio outputs on the S37
itself. The audio stream sampling rates
are not affected.
Please also note the limitations of the
different audio outputs in the "Unit rear
panel" chapter.
The volume control for the audio output
can be fixed through Volume control.
First, select a suitable volume while the
S37 is in play mode. We recommend
setting the S37 volume to the maximum
level, in order to achieve the best sound
quality.
Then fix the volume in the Settings menu.
From this point then, the volume control
is no longer done at the S37 but through
the amplifier, as with most of the other
sources.
Network settings
You connect the Revox Audio Server
into an IT network through this menu
item. You define the designation that is
used to identify the Revox Audio Server
in the network through the Device name
input. The factory setting for this
parameter is S37 followed by the serial
number, e.g. S37-12345. This ensures
that the name is not duplicated in the
network. You can also define the
Workgroup from your IT network in the
Device name area. The predefined
setting is "Workgroup". We recommend
that the S37 should operate in the same
Workgroup as the other devices in your
network. This significantly increases the
speed when identifying and searching
for other network components.
Through the IP Address/DHCP selection,
you define whether the S37 should get
its IP address by DHCP from your router
(Revox recommends using this setting)
or whether you want to assign a static IP
address. If necessary, please refer to
your System Administrator on this point.
You can also read out the S37's IP
address in this menu. Using this address,
you can access the S37's data levels
from external computers. You will find
further information about this topic in the
"File access" chapter.
An UPnP server is installed on the S37.
As the factory setting, this UPnP server
is activated but can be deactivated if
Summary of Contents for Joy S37
Page 1: ...Revox Joy S37 Audio Server Page 0 4 m1 ...
Page 4: ...Revox Joy S37 Audio Server Page 3 ...
Page 17: ...Revox Audio Server Remote control Revox Joy S37 Audio Server Page 16 Remote control overview ...
Page 70: ...Revox Audio Server Gracenote Revox Joy S37 Audio Server Page 69 User manual S37 audio server ...