Operation
Symphony
41
Operation - Start-up process
Once all the basic settings for the S208
remote control and the Symphony have
been made, you can start with the actual
operation.
Switch the Symphony on directly by
pressing the hotkey on the remote
control with the name Symphony. In the
example on the right, that would be
hotkey
A
. Alternatively, if no hotkey is
assigned, the Symphony can also be
started with the button combination
(System)
Device Selection [Figure 1]
Several Symphony present
If you are deploying several Symphonys,
it makes sense to give them different
names, so that they can be uniquely
identified in the device list or through the
hotkey assignment when calling or
starting them.
Now the S208 remote control initiates a
connection query to the corresponding
Symphony. [Figure 2]
Once a connection to the Symphony
could be established, but the network
connection is not yet completed, the
S208 remote control shows: [Figure 3]
The Symphony
always starts up with
the source that had been selected
before it was last switched off.
[Figure 1]
[Figure 2]
[Figure 3]
