R&D Department
Multiuser Card
Page 4
Configuration :
trigger
Room Trigger
This trigger executes commands if the operational state (standby / operational) of the M51/ M100 changes. Here, an
on
command can be defined if the amplifier switches out of standby mode (it is irrelevant what caused the switch-on). The
off
command is executed if the amplifier switches from active operation to standby mode.
Source Trigger
The source trigger reacts in a similar way to the room trigger. For certain sources of the M51 modules and M100 sub
modules an
on
and an
off
action can be defined for certain inputa. The
on
command is executed if, independent of the
cause, the corresponding input is activated. The
off
command is executed if the corresponding input was active and now
has been deselected through another source being played. Switching the M51/ M100 off also activates the off command
if previously, the source input was playing.
Note: The
off
command is not triggered as long as the corresponding source is playing in other rooms, i.e. the Source
command is not limited to the M51/ M100 where, for example, the source is installed.
In the menu
Source Trigger
there are 8 triggers [
Source 1-8
] for each Multiuser module with an
on
- and
off
command available. The
triggers are individually configured for each M51 / M100.