Band knife machine R750/R1000 – Instruction manual
Page
33 / 89
FPUH Rexel s.c.
ul. Radziwoja 11, 61-057 Poznań
tel.: +48 61 87 68 946
www.rexelpoland.com
4.1.3.
Setting the machine body
After unpacking, the machine must be set up immediately on a previously
prepared site with a forklift or a crane.
To ensure proper and safe operation, the machine must be set firmly so that all
supports (7) (pic. 2, p. 34) underneath the machine and top are in contact with
the floor. The floor surface should be free from cracks or defects which might
pose a risk to the operator and/or damage the machine.
Turning the screws in supports helps to adjust the tabletop height to existing
production line. At the same time it allows to set the table top in the most
comfortable position. After the adjustment, all screws and nuts on the supports
must be tightened and locked. Setting the band knife body must be done before
installing the tabletop and its supports.
4.1.4.
Setting the tabletop
Cutting accuracy of the material depends on the perpendicular arrangement
of the tabletop and the cutting band. This adjustment is made by manufacturer
but further minor adjustments may be needed.
Mount the tabletop as on the instructions below:
carefully unpack the tabletop
remove washer plates (1) (pic.1)
raise the band cover 12 (pic.2 p.38) turning the wheel (11) until it
stops in its highest position
carefully place the tabletop onto the supports (2), check if the
tabletop surface is properly levelled comparing to the bottom knife
guide. In case it is not levelled properly one has to adjust using nuts (3)
install legs using bolts M8, making sure that the leg with red handle
(4) has to be in the front right part of the table (see pic.1).
after all leg supports were assembled make sure to tighten all bolts
