Band knife machine R750/R1000 – Instruction manual
Page
45 / 89
FPUH Rexel s.c.
ul. Radziwoja 11, 61-057 Poznań
tel.: +48 61 87 68 946
www.rexelpoland.com
Cutting of the foam for upholstery is the same as the cutting of the fabric
layers. Before cutting upholstery foam, adjust the appropriate position of the
guide manual PR-3 (if available), in accordance with pieces of foam. To set the
guide, you must unlock 2 red handles, which guide the measuring stop in one
position. To unlock the handles, pull the handle on both sides of the guide to
each other. The cut material should be adjusted using both hands holding them
always on its surface. Do not lean on the table. After each work cycle turn the
machine off and lower the guard completely down.
6.6.
W
AYS AND MEANS FOR EMERGENCY STOP
In case of danger to health, life or property, choose one of the nearest
emergency stop buttons. Three emergency stop buttons are placed on the
machine.
The machine was equipped with covers with a safety door switch reacting to
their opening. Activating one of the circuit breakers or the Emergency Stop
Button will cause the machine to stop and enter the emergency stop mode. In
addition, a motor with a brake is used to drive the cutting band.
The brake is activated as a result of pressing the emergency stop button, the
button that switches off the band motion on the control panel, turning the main
switch to the OFF position or opening one of the covers.
For normal shutdown of the machine, use the main switch.
NOTICE
ATTENTION!!!
It is forbidden to use the emergency stop button to stop the machine in
normal mode!!! Only use it in emergency situations. Stopping the machine
by means of a safety button outside emergency situations or daily tests
may have an adverse effect on the operation of the safety system causing
its accelerated aging.
