Band knife machine R750/R1000 – Instruction manual
Page
49 / 89
FPUH Rexel s.c.
ul. Radziwoja 11, 61-057 Poznań
tel.: +48 61 87 68 946
www.rexelpoland.com
Press green button „START VACUUM CLEANER” (5) .
This will cause middle part of the button „START VACUUM
CLEANER” to glow.
In order to stop the vacuum cleaner:
Press red button „STOP VACUUM CLEANER” (6).
7.6.
A
IR BLOWING
(O
PTIONAL EQUIPMENT
)
It is a device that generates a blast of air that exits through the air nozzles
mounted on the work table. It has the effect of blowing air cushion thereby
facilitating maneuvering of cut material. To gain the best effect of the air
blowing between the top and the workpiece thin paper should be placed under
the workpiece. Tabletop may be manufactured without blowing.
7.7.
E
ND OF SHIFT
After the work on the machine is finished one has to turn it off using
MAIN SWITCH. Check the machine and perform maintenance according to
chapter:
7.8.
M
ACHINE MISUSE AND ABNORMAL USE
There is a number of possible cases for the incorrect use of the machine.
These cases set out below and limited to foreseeable misuse. One has to make
sure of following:
Do not use materials other than the appropriate types of upholstery
foam. It is only permissible to cut materials with similar properties,
unless it introduces additional hazards. It is strictly forbidden to cut
materials such as metal, wood, concrete and flammable materials
with the machine.
Use a protective mask when the workpiece is dusty or when cutting
dusty materials.
