DEM Page 24 of 43 FEBRUARY 07
PAPER SHREDDER S16 SECTION 7
SERVICE INSTRUCTIONS
REPLACING CUTTING HEAD
1. Remove the casing (section 2, page 4).
2. Remove the motor dust cover and lift out the bin full flap.
3. Note and disconnect motor wires from the rear terminal block, capacitor and earth screw.
Disconnect the wires from the bin full switch.
4. Remove the drive belt (section 2, page 6) and motor (section 2, page 12).
5. Unscrew 4 cutting head fixing screws and lift out the cutting head assembly.
NOTE
: 4
holes are provided in the sideplates for lifting with a hoist if required.
6. Replace the new cutting head assembly and reassemble in the reverse sequence.
7. Test the operation and adjust the cutter tension if necessary.
Summary of Contents for S16
Page 21: ...DEM Page 21 of 43 FEBRUARY 07 ...