DEM Page 36 of 43 FEBRUARY 07
HINGED GATE SAFETY SWITCH REPLACEMENT
1. Remove casing (section 3).
2. Remove the four screws, nuts and washers (1, fig 14) securing the switch bracket to
the main frame.
3. Remove the switch and bracket assembly ( 2, fig 14) and also the shaft support
bracket (3, fig 14).
4. Separate the switch and insulating cover from the bracket by removing the two screws
and nuts (4, fig 14).
5. Disconnect the leads from the switch.
6. Replace with new switch and connect the wiring.
7. Assemble in reverse sequence and test operation.
PAPER SHREDDER S16 SECTION 18
SERVICE INSTRUCTIONS
Summary of Contents for S16
Page 21: ...DEM Page 21 of 43 FEBRUARY 07 ...