GETTING ST
AR
TED
4
1. Powering the Camera:
Connect your camera to your vehicle via the included car charging
cable to power your camera and charge the battery while driving.
Connect the charger to the car cigarette lighter or 12V DC power
outlet, then insert the Mini-USB end of the charger into the Mini-USB
port on the camera.
4.3
•
You should always connect the camera to a power source
while recording
.
The internal battery is primarily used to save
files in the event of an emergency, and is only intended to handle
a maximum of 15 minutes of disconnected operation.
• If the battery is completely depleted, the device will not turn on
immediately when the charger is connected. Allow a depleted
battery to charge for at least 5 minutes before attempting to turn
on the device.
• If the device receives an unstable power supply while charging,
the screen may not function properly. If this happens, unplug the
charger from the device.
• While charging, the device may heat up. This is normal and should
not affect the device's performance or lifespan.
• If the device is not charging properly, take the device and the
charger to an authorized
Rexing
Service Center or contact
Customer Care.
Connecting the charger improperly may cause serious
damage to the device. Any damage caused by misuse is not
covered by the warranty.
Use only Rexing-approved chargers. Using unapproved
chargers or cables can damage the device or cause the battery
to explode.
11
10
POWERING THE CAMERA AND
FORMATTING THE MEMORY CARD
